Double check the cable and that could be your issue. Thats what I deserve for buying a RIB from E-bay, but I dont program motorola radios that often so what I have works for me. They both look the same, but you cant use one for both operations for some reason, even though the cables from motorola are the same. One works for mobiles, the other for the repeater. (Stupid, but its because the CPS also updates the radios firmware which may not work properly with older CPS versions which sort of makes sense)Īnother cause could be fake/improper programing cables. For instance, If the radio was programed once using a version 03.01.00 your CPS wont read the radio. If you use a newer CPS to program a radio, you must always use that CPS or newer, you cant roll back to a previous version. Motorola isnt like other radio softwares. Download codeplugs for APX 7000 (T30xx) and 8000 (T4000) RF modules. Download Motorola CPS Software and Cable Ordering Guide Download the TDFM-9000 Code-Plug Info PDF, This describes what codeplugs are used on what modules as listed above. This should give you the proper com port you need. Models TDFM-9000 /9200/9300/and TDFM-9100 Type I and Type II. To figure out which com port you need, go to device manager and look under USB Controllers. I suspect you have the wrong com port selected. Using USB cables usually puts you around com port 3 or 4, not 1. Most likely cause that I see is that you have com port 1 selected. First, make sure the radio is on (I know its a given if you have programmed radios previously but sometimes people forget)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |